Bacharach Gas Pup Instruções de Operação descarregar pdf (Página 44)

OPERATION GA-40 T plus

The last bank can be erased in the BANKS TABLE screen (the Bank may not be active)

Â and Ã - move the cursor to the last stored Bank

C - erase Bank

5.10.2.2 Erasing Banks

The option ERASE BANKS allows to erase all Banks.

Â and Ã - move the cursor to ERASE BANKS

Á - select the option ERASE BANKS

œ ATTENTION !

ALL BANKS

WILL BE

ERASED

ENTER - YES

À - leaves the screen without erasing BANKS

ENTER - erases all BANKS

5.11 Data-Logger

A data-logger is a instrument that measures variables that have been converted to an electrical signal and

stores them for later evaluation.

The inclusion of analogue inputs as shown below and the possibility of storing these results enables the

GA-40 Tplusplus to operate as a data-logger as well.

The analyser is fitted with the following inputs:

G two currents or voltages (V / mA)

G two thermocouples (Ni-CrNi / Pt-RhPt / Fe-CuNi)

G two resistance thermometers (Pt100 / Pt500)

The signals registered by the analogue inputs can either be read from the DATA screen or be stored

continuously in a bank, if there are channels free.

The WINFGA software can then be used for further treatment of these results.

{{ The ground (GND) of all analogue inputs is connected to the instrument

ground.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 57 58

Sem comentários

Bacharach Gas Pup Instruções de Operação Página 44