Bacharach Gas Pup Instruções de Operação descarregar pdf (Página 19)

GA-40 T plus OPERATION

0 to 9 . - the alphanumeric keys enter numbers in digital mode or letters in alphabetical mode.

Each key has a three letter designation. The first press enters the first letter, the next

presses the second and the third letter. Key presses in alphabetical mode does not

move the cursor.

0 - (SPACE) prints 0 number in digital and the space character in alphabetical mode.

The space moves all the next characters one position to the right..

C - (DEL) erases the character above cursor position. This moves all the following

characters one position to the left.

ENTER - ends the entering of a text (if only one line is edited - e.g. the name of a fuel) or

moves the cursor down to the next line (if there are several lines in the edited text -

e.g. the report header)

STORE - end the editing of a header or footer - it enables the storage of edited text. If you do

not need to store the contents of header or footer you should leave the screen by

pressing the MENU key.

5.2 Basic operating instructions

5.2.1 Setting-up the analyser

Connect the components of the analyser system

G Attach the hose to the connector GAS. The plug from the heated hose connects to the socket

HEATED LINE.

G Ensure that the gas flow from the base of the analyser is free of obstructions.

If a soot test is to be carried out, then the folowing is also needed:

G heated probe holder

G soot filters

G soot comparison scale

5.2.2 Switching on

Before use, the condition of the analyser should be checked:

G Check the filter element. Clean or replace as necessary.

G Check the state of charge of the battery if the analyser is to be operated from the internal

battery. This is carried out by switching on and reading the battery voltage or charge from

the initial screen, or from the screen MENU/OPTIONS/DEVICE INFO.

5.2.3 Switching off / Standby

Pressing the key [OFF] once will switch the analyser to the STANDBY mode.

In STANDBY mode the power consumption is drastically reduced. Amongst others the pump and the

backlight are switched off. Only the sensors remain supplied to be ready to operate immediately after the

instrument is switched on again.

The analyser does not switch to STANDBY mode if [OFF] is pressed in case:

G the key is being pressed during initial calibration. In that case the instrument notes the action,

but will switch to STANDBY only after the calibration is finished.

G the key is pressed while there is still a high gas concentration detected in the gas chamber. In

this case the instrument will automatically switch to FLOODING WITH AMBIENT AIR

mode and switch to STANDBY later on.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

Sem comentários

Bacharach Gas Pup Instruções de Operação Página 19