Bacharach Gas Pup Instruções de Operação descarregar pdf (Página 42)

OPERATION GA-40 T plus

The pictures show screens without text.The screen appears as it was when the report was stored. How the text

should be edited is described in section 5.1.4.

This screen can be left at any time using [MENU] and [DATA].

5.10.1.4 Erasing Reports

All protocols can be erased in that option.

Â and Ã - move the cursor to ERASING REPORTS

Á - select option, the following warning appears

œ ATTENTION !

ALL REPORTS

WILL BE ERASED

ENTER - YES

À - leaves the screen without erasing the Reports

ENTER - erases all Reports

5.10.2 Continuous storing of results

This type of storing involves the continuous storing of a set of up to 10 measurement results (ONE BLOCK)

during a measurement session. The EEPROM can store up to a total of 1024 blocks freely dividable between

10 measuring sessions. These 10 sets of results are known as BANKS. The size of a single bank is only

limited by the free memory available. Each bank also contains all necessary information about the

measurement (fuel, time, O2R, averaging time etc.). All the results stored are average results for the time set.

If the analyser is switched off, and under certain circumstances, the storing of averaged results will stop

automatically.

This is signalled by a single long warning tone.

The following table shows the contents of a data block.

LZ Measured Value Description

1 TEMP. AMBIENT

2 TEMP. GAS These parameters can not be changed,

3 SENSOR 1 - O2 they will be stored in each block,

4 SENSOR 2 - CO together with the results from all other

1 SENSOR 3

2 SENSOR 4

3 SENSOR 5

4 SENSOR 6

5 TEMP1 EXT Out of these parameters, the ones activated

6 TEMP2 EXT will be stored with the data block,

7 TEMP3 EXT assuming that there are channels free

8 TEMP4 EXT

9 U/I 1 EXT

10 U/I 2 EXT

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Sem comentários

Bacharach Gas Pup Instruções de Operação Página 42