Bacharach Fyrite INSIGHT PLUS Manual de Instruções descarregar pdf (Página 21)

Fyrite



INSIGHT



Plus Manual Setup

0024-9487 Rev 2 15

Section 2. Setup

2.1. Connecting the Probe and Thermocouple

A rigid stainless steel probe with handle is connected to a flexible hose with an

integral water-trap / filter used to draw a gas sample into the analyzer from the

room, grills, diffusers, and furnace flues. Refer to page 6.

1. Inspect the sample gas hose for cracks. If a hose is defective, replace the

entire probe assembly.

2. Before using the analyzer, check that the water trap/filter is clean and dry.

If necessary, dry out the trap and replace the filter element (see page 81).

3. Push the probe’s sample gas hose onto the GAS inlet connector.

4. Push the probe’s draft hose (+ ∆P) onto the “+” pressure connector.

5. Push the probe’s thermocouple into the T-STACK connector on the

instrument, noting its orientation.

IMPORTANT: The T-STACK connector tabs are keyed to fit

into the connector in only one orientation. DO NOT force the

thermocouple connector tabs into the T-STACK connector.

6. Push the optional ambient/primary-air thermocouple into the T-AIR

connector.

NOTE: Refer to page 6

or locations and details of

components.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 115 116

Sem comentários

Bacharach Fyrite INSIGHT PLUS Manual de Instruções Página 21